6ES7158-0AD01-0XA0 SIEMENS DP/DP Coupler

Description

6ES7158-0AD01-0XA0 SIEMENS DP/DP Coupler

Product Dimensions：

Product Description (Detailed Explanation)

The DP/DP Coupler is a compact, rail-mounted device that functions as a “slave” on two separate PROFIBUS networks simultaneously.

• Data Exchange Bridge: It bridges the gap between two PROFIBUS DP lines. Each side of the coupler acts as an independent DP slave. Data written by the master of Network 1 is read by the master of Network 2, and vice versa.

• Electrical Isolation: The two PROFIBUS interfaces are galvanically isolated from each other. This prevents electrical faults or noise in one network from affecting the other.

• Independent Configuration: The networks can operate at different baud rates and have different bus parameters.

Product Parameters (Technical Specifications)

Product Advantages (Key Benefits)

• Network Decoupling: Allows for the separation of machine networks. One manufacturer can supply a machine with its own internal PROFIBUS network, and the coupler allows it to talk to the plant-wide PLC without merging the bus traffic.

• Simplified Integration: No special software or complex programming is required; the device is configured in the hardware rack of the PLC (Step 7 or TIA Portal) as a standard GSD-based slave.

• Redundant Power Supply: Supports two independent 24V DC feeds, ensuring the communication bridge stays active even if one power source fails.

• Baud Rate Flexibility: Network A can run at 1.5 Mbps while Network B runs at 12 Mbps without conflict.

Precautions (Important Notes)

• Consistency: The I/O configuration (the length of input and output bytes) must be “mirrored” on both sides. If Side A is configured for 10 bytes OUT / 5 bytes IN, Side B must be configured for 10 bytes IN / 5 bytes OUT.

• DIP Switch Setting: The PROFIBUS addresses are set manually via physical DIP switches under the front cover. Ensure these are set before powering on the device.

• Bus Termination: Like any PROFIBUS node, if the coupler is at the end of a segment, the termination resistor on the PROFIBUS plug must be switched to “ON.”

• Diagnostic LEDs: Monitor the “SF” (System Fault) and “BF” (Bus Fault) LEDs. A BF LED on one side usually indicates a configuration mismatch or a disconnected cable on that specific network.

Product Applications (Typical Use Cases)

• OEM Machine Integration: When a factory owner needs to connect a third-party machine (with its own internal PLC) to the main factory SCADA system.

• Cross-Controller Communication: Connecting two S7-400 or S7-300 PLCs that belong to different departments or sub-processes to exchange interlock signals.

• Protocol Isolation: Protecting a critical control network from the high traffic or potential electrical issues of a peripheral I/O network.

• Large-Scale Plants: Facilitating communication between a Siemens-based system and a non-Siemens PROFIBUS master (e.g., ABB or Schneider) without requiring complex Master-to-Master communication setup.

Shipping Port: Xiamen, China

Payment: Bank of Chicago, Bank of Singapore

Express cooperation: fedex, DHL, UPS and your express account

Service: Professional Sales provides 24 hours /7 days online service

Please make an inquiry for more models：